Up to 50% of all electric/ electronic component failures are caused by corrosion. Corrosion in electronic components is insidious and cannot be readily detected. When corrosion failures occur, it is often dismissed as just a failure and the part or component is replaced. The most common reason for corrosion-related failure is atmospheric humidity and environment contaminants(dust,etc.).
Ship-2-Shore PLID and Industrial Wet Films are dielectric high performance protection from moisture and corrosive contaminants. When applied, Ship-2-Shore films form a dynamic, non-hardening, dripless and self-healing coating.
Heating and cooling of electric and electronic components from use, causes expansion, contraction and condensation, resulting in cracking, separation and moisture intrusion of traditional coatings, self sealing connectors, etc. Once cracks form and separation occurs, moisture, oxygen and contaminants intrude and become trapped, resulting in corrosion and premature failure.
Ship-2-Shore PLID Thin Film ( 40,000v dielectric ) - Makes an excellent thin, extreme penetrating, all purpose anti-corrosion, anti-seize and high pressure lubricant film. Ideal for electrical, electronics, circuit boards and mechanical. Float Coat PLID for difficult to access cofferdam voids, void between double hulls, tanks, rudder void, keel, etc.
Apply with aerosol spray, brush, mop, airless paint sprayer or floatation method. 1 litre covers up to 100 sq ft. Apply to bare metal, over paint or other hard coatings. Can be applied to damp surfaces.
Ship-2-Shore Industrial Thick Film ( 8920v dielectric ) - "thick" heavy duty, anti-corrosion, high pressure lubricant wet film coating. Ideal for long lasting corrosion protection under difficult, extreme conditions and just about anything else. Suitable for workboats, barges, ships, anchor chain, wire rope, offshore structures, deck equipment, electrical, vehicle corrosion preventive undercoat, etc.
Apply with brush, cloth, mop or airless paint sprayer. 1 litre (1 quart) covers up to 50 sq ft. Apply to bare metal, over paint or other hard coatings. Can be applied to damp surfaces.
PLID Thin penetrates deep, watch it get to the core of this tightly bound steel cable protecting it from the middle out. For extra protection use the thicker films as a top layer, cable remains rust free and fully flexible!
Watch the PLID Thin film creep up the metal, this is the self healing action caught on camera. This is why the Plid Thin film makes a great penetrant, creeping up rested bolts leaving them fully lubricated.